• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Recent content by paulsbox

  1. P

    Cobra 2000 Gtl faceplate

    Anybody have a junk 2000 or a good faceplate?
  2. P

    RCI 2980 AM\FM RX

    Replaced L3, fixed it. Anybody have a sir/power meter for the rci2980?
  3. P

    RCI 2980 AM\FM RX

    anybody have an interconnect diagram for the rci2980? It’s kind of a butchered radio some of the wiring has been unhooked.
  4. P

    RCI 2980 AM\FM RX

    I got it this way, found L3 to be bad. Ordered one, ill see if that fixes it. Thanks
  5. P

    RCI 2980 AM\FM RX

    I have a RCI2980 EPT3600-14b board everything works, but I have no rx on am or fm but it tx on them, but its fine on ssb. Any ideas on what to check?
  6. P

    Help Uniden Grant XL

    It was c117, it had a 220pf don’t know if someone changed or not. It did have a expo kit in it. There is a L59, there was 2 different board on the grant xl, mine has the pb-208 board the other bleary that was used was the same as the older 148’s
  7. P

    Help Uniden Grant XL

    Update found problem, had the wrong ceramic capacitor in circuit. Had a 220pf a was suppose to be a 470pf. Thanks
  8. P

    Help Uniden Grant XL

    which one, i replaced the 11.325 and the 10.240 checked ok on counter.
  9. P

    Help Uniden Grant XL

    The radio will rx and tx, its just off frequency you can really tell on ssb. I tried turning the clarifier, but it still doesnt allow me to get below 35.167. yes i have a frequency counter, scope, vom, & signal generator.
  10. P

    Help Uniden Grant XL

    Yes, shows channel 19..
  11. P

    Help Uniden Grant XL

    Uniden Grant XL PB-208 board. Can't get VCO frequencies to set. Alignment calls for AM L23 34.985 LSB L22 34.9835 USB L59 34.9865. I can not adjust it down any lower than 35.167 mhz. Changed the 11.325 crystal, changed L23 and check some diodes nothing made any difference.
  12. P

    M105 hairpin

    will that cause all the elements to be changed or just the driver?
  13. P

    M105 hairpin

    getting ready to setup a m105 with hairpin match. Splitting and isolating the driver element, does the length need to be changed or can I leave it stock?
  14. P

    EPT360010a

    Thanks, ill give it a try. The 10a board was the earliest one used in the Saturn. they had 11,12,13, and the 14 revisions.