• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

tram d201` hand wired vox version

Jul 9, 2008
10
0
11
lost power and swing about half as much now tubes are ok alot of money in this radio all new caps most resistors any ideas ? also has been aligned etc.
 

how is the ssb power is it ok or is it gone too? if it,s ok then check out the compresor cicuit their are two diodes their that can go bad....hope it helps
 
Tram D201

My Tram had the same issue. It was the 12BY7A tube socket for the driver. Cleaned it up and realligned the tube pins. Was only doing 1.5 watts on low power. After I cleaned the socket and tube pins it runs 3 watts on low and 12on high and is back to normal.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated