Soldering Irons

Captain Kilowatt · Jun 3, 2010

W5LZ said:
I figure that 'Pace' is about like Nissan and Toyota, which are both assembled here in the USA from parts from other countries. Or Fords and Chevys which are sometimes assembled here, from parts sometimes made here.
For $700 dollars, I think I can substitute a little work and skill in soldering, and have enough left over for a lot of beer.
- 'Doc

I'm with you Doc. There is no way I could ever justify that kind of money for a solder iron/station. If I was a company owner that needed reliability and repeatability of performance then maybe that would be a different story. I worked in broadcasting for 22 years and never had a solder joint fail in all that time ( and there were tens of thousands of them trust me) nor did I burn up half the insulation while wiring studio interconnect wiring cables. Sometimes somethings are just way overestimated. At times I think it is because the manufacturers are trying to eliminate skill and replace it with what they THINK is better.

Cityboy · Jun 3, 2010

Like I said the Pace line may be expensive and not for everyone, but just as Captain Kilowatt said if want reliablility and dead on accuracy which can be very crucial in certain applications then the use of a Pace equipment is one of the best. I did not purchase mine brand new and have a total of $320 into my SX90 desoldering hand piece and ST-90 soldering iron with another $45 in soldering tips and desoldering. So quality can be had at a reasonable price if you know what to look for. This is just a personal preference and the Weller is a very good one but my Pace is definitely better.

Search

Soldering Irons

Captain Kilowatt

Professional Amateur

Cityboy

Active Member

Settings Notifications

Options