-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
My First Attempt At A Mobile Antenna
- Thread starter HomerBB
- Start date
Hey doughboyx can I get an exploded view of your mounting section and the top. If you have the time.
@Robb:
Barefoot: Channel 1 1.0:1, Channel 20 1.0:1, Channel 40 1.05:1
With a 100 watt dead key channel 1 1.2.:1, channel 20 1.2:0, channel 40 1.3:0
As for receive so far it is very good but to early to compare. Will work it for the week and hope to have a good comparison by then.
@crmzendrgone:
I used the antenna ferrule from another antenna so steel whip can slide up and down.
Barefoot: Channel 1 1.0:1, Channel 20 1.0:1, Channel 40 1.05:1
With a 100 watt dead key channel 1 1.2.:1, channel 20 1.2:0, channel 40 1.3:0
As for receive so far it is very good but to early to compare. Will work it for the week and hope to have a good comparison by then.
@crmzendrgone:
I used the antenna ferrule from another antenna so steel whip can slide up and down.
I don't mind you posting to this thread. However, you might want to make your own thread just to show it off. It's really good looking. 
Last edited:
So for my education purpose the coils are made out of smaller meterial on this on???
(I couldnt tell if my life depended on it:redface
If I understand your question, the reason the coils on this one is smaller is because I couldn't get a larger diameter steel coiled tubing at the local retailers.
That look good how to you keep the spacing right?
So is the plastic tubing in the middle so that the current/signal(what ever it is called) bypasses the tube and goes through the coils?
So what I am thinking is it electrically(?) sperates the tube and routes it through the coil
So is the plastic tubing in the middle so that the current/signal(what ever it is called) bypasses the tube and goes through the coils?
So what I am thinking is it electrically(?) sperates the tube and routes it through the coil
I roll the tube around a large piece of PVC to form the coil, and then pull the spaces apart by hand to acheive more even separation between each wrap of the coil.
Yes. The PVC insulator in the middle breaks the upper from the lower tube so that the current has to use the coil to make the connection between the two shafts.
I've got it on top of the SUV, now.
How is this mounted? Could you take a close up pic of the mounting?:redface:
Thanks!
