-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Can someone tell me this pipe size?
- Thread starter Se7en
- Start date
Thanks for the answer. Now to find a antenna tripod with that diameter
★ Sent from my Droid★
http://www.solidsignal.com/pview.asp?p=CM9003&d=Channel-Master-CM9003-3-ft-Tripod-Mount-(CM-9003)
Its OK if the diameter is bigger than my mast?
Just using it with a 12foot mast and my 27 foot 10m antenna in the backyard
Sent from my Xoom using Tapatalk 2
Channel Master CM9003 3 ft Tripod Mount (CM-9003) from Solid Signal)
Its OK if the diameter is bigger than my mast?
Just using it with a 12foot mast and my 27 foot 10m antenna in the backyard
Sent from my Xoom using Tapatalk 2
Yeah, it's hard to tell from that pic but there are two sets of bolts on the top and bottom of the tripod mast mount. You just screw the bolts into your mast size and tighten them down.
BJ radionut
Supporting Member and 6m addict
Steren Satellite Antenna Tripod by Office Depot}
Winegard SW-0010 Tripod Antenna Mount : Tripod Antenna Mounts | RadioShack.com
Make sure you stake it down!
All the Best
BJ
Winegard SW-0010 Tripod Antenna Mount : Tripod Antenna Mounts | RadioShack.com
Make sure you stake it down!
All the Best
BJ
it does look like a 1.25 OD as he has the tape sitting across the pipe,but he has the tape off centered in relation to the pipe,if you follow the curve of the pipe around to the other side of the tape it should be really close to the 1.5 inch mark
Look at the center line of the tape. It is pretty much centered and reads 3 cm across which is around 1.2".
OK Duster ya got me ...I didnt look at teh center line of the tape..... it falls somewhere between 1 and 5/16 and 1 and 3/8 inch ...still will make a good antenna pole
...I didnt look at teh center line of the tape..... it falls somewhere between 1 and 5/16 and 1 and 3/8 inch ...still will make a good antenna pole 
1-1/4" OD thin-wall tubing. Does not look like a "genuine" section of iron pipe, maybe really old and rusted fence top-rail?