I’ve got a 447 I’ve checked the finals and drivers and no transmit the AWI is flashing recieve is fine but no tx
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Stryker 447 hp
- Thread starter bluecurt63
- Start date
I would first check your SWR. Your AWI will flash if your SWR is high or if your PLL is out of lock. Not sure how much technical knowledge you have but if your SWR is good I would check to see if your VCO/PLL is in out of lock condition or even check around the pre-driver area to see if you have RF going to the driver/final section.
Cold solder joint??? Re-flow transistor legs to solder pads on main board and give that a try.