• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Echo settings

Ziploc

Well-Known Member
Mar 19, 2016
299
135
53
52
Good morning all, I had some help from someone on here that gave me a good starting point. That being said I was curious to know were you all run your knobs on your echo? The outter knob being gain and the inner round 1 being the delay.Yes I know there a lot of boards on the market and radios, just curious were y’all set them . Thanks. Thanks
 

Toke , You just had to post a pic of that damn Noise Gate ! :whistle::LOL: I been holding off buying one but must say when set right it gives a nice Audio quality ! (y) I'll be checking Ebay again in a few minutes . Thanks a lot Pal ! :ROFLMAO: Stay Healthy & Safe ! 73 & God Bless ! Leo
It's a little more than noticeable but not obnoxious. I like the unit. I'll admit I haven't used it much on ssb but I get great reports on am.
 
  • Like
Reactions: snippits75
Toke , That would be my concern , I had my Silver Eagle modded to some of the high pitches out & also have a Sadelta Cm-40 compression mic I use on SSB . But after seeing your post doing some research they have a Vid on Youtube and the Op is showing how one similar to yours (?) performs on SSB , sounded decent to me ? :) Also the S meter was showing a lot more compared to when he was using his stock mic ( he points this out in vid ) . Stay Healthy & Safe ! 73 & God Bless ! Leo
 
  • Like
Reactions: Tokin
The EQplus from w2ihy has it, but it is off all the time, improving readabillety of the audio, one reason i speak in the table mounted mike from the side 2 inch distance.
No echo, downwards expander tight, no room sounds to get into my signal.
Th excellent internal Eqplus compressor/limitter takes care of the rest, radio compressor off.
Equaliser tone control used sparingly, mostly adding some lows in FM only.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • dxBot:
    Tucker442 has left the room.
  • @ BJ radionut:
    LIVE 10:00 AM EST :cool:
  • @ Charles Edwards:
    I'm looking for factory settings 1 through 59 for a AT 5555 n2 or AT500 M2 I only wrote down half the values feel like a idiot I need help will be appreciated