You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Hi..
I installed only the driver 2166 which is new, and tested current on the test points..it goes from 0.30 to 1.3 and I stopped there, was getting to hot...all trimpots are adjusted accordingly by the service manual..any suggestions?
could be..although it was bought from a shop, not online..
In case I get a genuine, and it happens again, what should be checked? there was a bit burned 100 ohm bias resistor, and I replaced it for a new one
I have a TRC 449 that has the same test points bridge..thinking about comparing current idle and activity at the test points, to see if both act similar
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.