Search results

Thanks, I will check the output network after work today. That simsmith is fascinating and I will get that too. I thought about connecting the network to the nanovna and figuring what it is doing and, thanks to you, I have some ideal data to check against. This radio has a 2166/1969 combo, all...

Thanks, I have the Sam's for it, I aligned it okay, only small gain. 3.5dk\14 pep. I'm going to check the other parts of that 27mhz filter, maybe a cap has drifted, been changed, etc. I wonder if that is part of some mod, it doesn't look molested but I haven't hard-eyed the parts values and...

Found above radio in a friend's shop, buried under random shop stuff, you know. He gave it to me, knowing I tinker with them. Sometimes I get blessed like that. While looking over my new pet, I noticed L38 was missing his slug. I dropped one in and it immediately dropped power output. Peaks...

I built the Lou Franklin speech processor\clipper about 6 years ago or better. I didn't have the pre-made board, only a schematic and some proto board. I was able to build a working version but couldn't get it to stop feedback squeeling using it for CB. It works great away from a radio, say...

I understand, the preamp is of very little value to me, but it's there and I want the switch it's connected to to do something when flipped, like the band selector, as much as I want to remove it with the business end of a crowbar, leaving it just feels wholesome. So, 3 watt for the bleeders?

The bleeder resistors on the hv caps, are those 240k 3 watt? Lastly, there is a component missing on the relay board of mine, per the schematics it appears to be a capacitor (.01uF?) for the rec amp. Do you know if that is correct and why someone might snip it?

I agree, I wouldn't have jumped to that conclusion first either, but we don't know the extent of the previous conversation in which that was suggested. I'm merely pointing out that it is not that far out of the realm of possibilities instead of bashing the ideas from persons unknown to this...

I wouldn't say he was real far out there, just thinking on a different wavelength. Corrosion caused his issue with the plug, but also, copper in contact with aluminum WILL cause galvanic corrosion in the presence of moisture and that COULD cause an issue. It's that "outside the box" thinking...

That's fantastic nomad, and I'm a fan. I am fixing to refurb a 300a (low volt) and want to know more about the mods you perform that the factory dropped the ball on, such as the parasitic chokes, I've seen the resistors in a coil before but how do you determine the resistance and inductance when...

I second this, this book should be in everyone's library. I've hoarded and read many technical books and arrl pubs but this one is very different. I wish I had gotten hold of it sooner so thanks for this referral @nomadradio.

Heard this on my favorite show, a rendition of "Dink's Song" or "Fare Thee Well."

I'm tempted to buy it for the wife's car. If I do I will review it. It's cheap enough but might take the rest of the year to arrive. They take PayPal so I should be covered.

Well, I wouldn't. Im recalling a mod, shorting all the caps from board gnd to chassis gnd in an attempt to make the Rx less noisy iirc but I tried it once with bad outcome. I'm not sure as to why you are probing the mic and wanting to short grounds? What are you looking for? To make sure the mic...

Also, I'd look at the mode switch and circuit concerning your issues.

Often chassis ground and dc or board ground are different. Measure ground from a tuning can, as it's connected to "board ground" and the chassis usually has isolation via ceramic capacitors. Most have a can that is bonded to a crystal with a wire, that's where I clip my lead grounds for all...