Search results

Working on a connex cx3300 hp with no tx. Was thinking something was wrong with the pll section of the board but its receiving fine. Have no transmit on AM or FM. I have another radio sitting on the bench on and when I key the mic on the connex I'm getting a signal on the other radio but no...

I just picked up a Cobra 29 ltd chrome that's not working. Radio is as dead as a door nail. Doesn't power on or anything. Looked for cold solder joints and anything burnt up but it all looks good. Any ideas of what else to check?

Anyone have the conversion information for the new galaxy 33HP2? CB tricks only has the info for the older ones.

Just picked up two connex cx3300s. One is newer and the other one is an older readio. The newer one has no modulation on AM but works fine on FM. The older one works fine on both AM and FM but has low modulation. R228 has been cut in both radios so I would assume they should both have plenty of...

Ive got a Northstar NS-9000 I'm working on now. Radio is pretty much dead. Other than a little bit of noise from the speaker is does nothing. None of the lights light up or anything on it. Would a bad voltage regulator cause that or am I looking in the wrong spot?

I have a General Lee here Im tinkering with. The radio is loosing receive and transmit. When you key the mic the RX/TX led will not change color. Its not a mic problem as Ive tried several different mics and it still does the same thing. Any help would be appreciated!

I have a cobra 29 ltd classic I'm working on here. The radio appears to have been hooked up backwards at some point. I had to replace the reverse polarity diode and re solder a burnt trace on the board. The radio powers up now but the receive isn't acting right. When receiving any station the...

I have a galaxy 66 I'm having trouble with. When you turn the radio on the frequency counter shows 25mhz or so and it starts jumping through the frequencies. I replaced the 10.240mhz crystal and it worked for a short time. I started going through the alignment procedure and half way through it...

What can be done to increase the power on a cobra 25 other than changing the final? Seems like most of the radios I see are set at about 2 watt dead key and they won't do much more than that. Ive got one sitting on my bench right now thats set at 2 watts dead key and will barely hit 5 watts...

Whats all involved in switching the final (2078) in a Cobra 25 ltd classic to a 1969? Is it as simple as just removing the 2078 and putting the 1969 in its place or are there other components that need to be changed?

Anyway to further increase the modulation on Cobra 25 ltd classic without cutting the limiter or using a power mic? Ive got the VR maxed out.

Looking for the full alignment info for mosfet general lee. One of the local hack shops had their hands on it and its pretty screwed up! Also was wondering why the voltage regulator is getting extremely hot?

Looking for the tuning and alignment information for a uniden pc68xl.

Nice making contact with you again!

CONNEX AM/SSB CX566 40 CH Interesting!

Looking for the alignment info for a Midland 5001z. Radio is a bit of freq. and the power and modulation are low.

Wondering what the shaft length is on a Monkey made MM-6?

YouTube - Why is Chrysler doing so poorly and should it receive a bailout? YouTube - dodgechryslersucks's Channel Before You Buy Dodge Vehicles - Chrysler Cars Trucks Minivans Suvs Thought some may find this interesting.

Looking for some info on this radio. Cant find any mods or info on it. Would like to tune it and adjust the power. Thanks!!

Wondering what software this radio takes to be programed. I searched all over just trying to get some info on them with no luck.:confused: Was able to locate 730 software but its not G specific so it does not work. Tried contacting kennwood as well and they have yet to reply.:thumbdown: I have...