• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Search results

  1. KennyD

    +8v on TX only on Uniden 980

    Hey guys, I'm hoping someone here could tell me where to find a +8v source on transmit for a Uniden 980? I want to put a RFX-85hd on it.
  2. KennyD

    Uniden PC-122 help

    Uniden PC-122 help. I picked up two PC-122's, one is an XL. Both radios had frequency expanders & unlocked clarifiers installed in them. Neither radio would align worth a damn onto the center notch so I want to return them back to stock. I removed the channel expanders but they still won't...
  3. KennyD

    KL203-p for QRP SDR use

    Hi, I just built a Peaberry SDR for 10 meters and I now need a PA as the radio only produces .091 watts on TX . I have a KL203-p that I put in line to use the pre-amp for the receive and that works well but just as suspected, the Peaberry does not have enough output to drive the KL203-p...
  4. KennyD

    Browning Golden Eagle Mark IV-A off freq

    A friend of mine has a Golden Eagle Mk IV-A that is transmitting 3 channels off frequency. Receive is fine. But here's the kicker, Channel 12 is un-effected. So for example if you tune the radio to Ch.14 it transmits on Ch.17. and 3=6 and son on. EXCEPT for channel 12. Any ideas? is the PLL chip...
  5. KennyD

    Hum/buzz Noise In My Radio

    He y'all. I have an RHF-618 (same board as a 2950dx). It recently developed a humming/buzzing type of noise in my transmit audio. My first thought was a bad power supply as it is a base radio so I switched it from 110vac source to 12vdc and it still does it. Could this be a bad filter cap? Any...
  6. KennyD

    Galaxy 2547 USB won't align

    I have a Galaxy DX 2547 that all of a sudden sounds terrible on USB and it used to be great. I opened it up and proceeded to check the alignment with my B&K 1805 freq Counter and I found that all is well EXCEPT the USB Transmit section. The counter will not stabilize and just wanders around...
  7. KennyD

    JC Penney 6241 info needed

    I'm looking for test and alignment points for a JC Penney 6241. I have searched these forums and found very little information. Also if anyone knows, What is the purpose of the "pilot light" inside this radio? Thanks in advance for any help. For anyone else looking, Here's the info I have...
  8. KennyD

    JC Penney 6241 needed

    I'm looking for test and alignment points for a JC Penney 6241. I have searched these forums and found very little information. Also if anyone knows, What is the purpose of the pilot light inside this radio? Thanks in advance for any help
  9. KennyD

    Uniden 980 alignment notes

    Hello, I have been searching the forums for alignment procedures for the Uniden 980 and haven't found anything. What I need is the PLL alignment points and procedures for this radio. Here is what I figured out for the OSC, I will list it below. Set radio to channel 20 USB OSC - Connect Freq...
  10. KennyD

    BK 2040 technical help?

    I recently picked up a B&K 2040 signal generator and I'm looking for someone familiar with this test equipment. I have the service and operation manuals. I was going thru the alignment & testing procedure for this unit and I believe I found a problem. With a 10 digit freq counter connected to...
  11. KennyD

    B&K 1040 CB Service Master Operating Manual

    Hey y'all. I am looking for the Operation Manual for the B&K 1040 CB Service Master. I already have the service/tech manual. Would anybody here have a PDF copy? I've been searching forums and google and all I can ever find is the service manual.
  12. KennyD

    Cobra 29LX BT Low power output

    I just picked up a Cobra 29LX BT for 100$ that has a 520 Mosfet tuneup and a TIP120 variable power mod. According to my meters, the carrier output is no more than 2 watts max but swings 15. The variable is connected to the RF Gain pot and with the power turned all the way down it has no carrier...