Search results

When conditions are rocking on the 28 AM, does anyone know the story on the banjos? Such location, history, anything? Thought it might make an interesting thread.

I have one of these that seems to work fine, but it requires about 10 watts of dead key to fire(TX) anything below that it will not TX and close to 10 watts the relay will chatter on voice peaks. This seems high, but that amp functions fine and sounds fine on the air. I feel like somebody modded...

I have a KL-7505 that, I have some questions on. I set this amp up with a 2950dx with a md-1. I set the radio using my scope and it sounds fine and I normally run about 200% modulation. When I paired this combo up to the 7505. I found the amp really only likes to run to about 20 watts dead key...

I have the radio mentioned in the subject. It currently has. -No receive audio, does receive an RF signal but no audio heard from the main speaker or external. - PA function does not work either. -if you turn the radio on/off you can hear a brief burst of static. Here is the interesting part...

Anyone know about instructions for the MD-1 mentioned for the radio in my subject? I see there are instructions on the topgun site but not specifically for that radio. I'd like to get a clean wave form over 100%.

I have the amp listed in the subject. I noticed today, that the input tune was high, this is a new to me amp. I know the coax is fine and antenna, I've been thru that. This amp has two pills, not FETs inside, I noticed on top of the transformer the silver mica cap was burnt and it measured about...

I have a ranger 2995 DXCF that I believe is 100hz high in frequency. AM seems fine, but I noticed on LSB when I turned my radio to channel 37 (27.3750) that actually using the VFO and tuning to 27.3749 puts me right on channel 37. I found the 2995 DX manual online detailing the alignment points...

I'd like to obtain a service manual for my radio to keep on hand. I found a 2995 DX manual online. Does anyone know if that is the right manual? I bought this radio new less than a few months ago.

So I am looking for sensible beam suggestions. I have available a 50 foot tower and heavy duty rotor and thrust bearing. Here's my criteria - must be in current production readibly able to find. - Nothing that comes from over seas needs to be available in the US (shipping prices). - I want...

I've decided I want a 2970n4 and a 2995dxcf. Can anyone recommend a reputable vendor? Also is "tune and alignment" nessecary? I'm fine doing an 11m conversion myself, but I just want a clean radio that jas 100% modulation and meets spec.