Search results

I've got some gear I want to trade... Ideally I would trade it ALL for a working all mode HF rig WITH general coverage rx. Pretty much all of my stuff is in need of a little TLC. I would rather get rid of it all, and just have one(functioning) radio. Kenwood TS-520S: Missing side vox...

I have a TS-520S sitting around here that I would like to get rid of. Would LOVE to trade for something all mode with general coverage rx. I put new tubes in it and never dipped(?) them, so that needs done. Thanks

I need a 5K pot used for the SWR on a HR 2510. I cannot seem to find one. Any idea on where to get one would be great. Thanks

I need a mic for my Kenwood TS520s.. I have been looking at the Astatic mics because they are cheap and I read good things about them online. Any input? I just need a simple handneld mic that will work with the TS520s Thanks PS do these mic's have a nice heft to them?

I am having display issues. The display shows all 8's, LCD's all light up. I figured out that if I lower the voltage of my pwr supply to about 8.5vdc the display works fine. IC312(?), the 7805 voltage reg, has an output of 10v with normal pwr supply input. And it is about 5v with the pwr...

So I downloaded a manual for my new TS520s and I am try to do an alignment. I am following the manual but when I tweak the appropriate coils the S meter does not move. From what I understand I should be tuning the coils for max S meter deflection. I am pretty sure I am doing it right because...

I got a couple of HR2150 problems... they are posted in the CB tech and repair section. BUT since I am only going to use it as it was intended, 10meters, I thought I would direct any help from the HF ham side over to my post(s)...

I cant find a schematic or anything online. I now have destroyed 2 resistors while removing that damn epoxy crap. They are on the back of the cpu board. And of course they are not labeled. If you flip the board over with the cpu IC on the left you will see 3 resistors mounted in a row...

New 2510....10volts out of IC312 should be 5v I just got a 2150... it's broken and I already knew that when I got it. It has display problems but does still TX. I am looking in to the display.. My problem in IC312 has/had a diode from the center pin to ground... it sorta fell off(really...

I am know there are a LOT of those illegal 11 meter amps floating around. Is there one that I can get that is actually a decent amp to work 10 meters with? I am not too interested in putting out a nasty signal on 10 meters. I like tube stuff and I am eye ballin a Midland K1313... can I...