You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Thanks guys!!
I think I know what’s going on, and some folks out there did the same as me, bought cheap ceramic screwdrivers!!! After using heat. Cleaning the wax off the slug and the can I very gently broke a slug! Culprit is a wedged tip on the ceramic driver. It fits great until you...
HI y'all,
I bought a connex 3300 and the slugs in most of the coil cans are broken, I have a friend who bought a used connex 3300hp, slugs broken also, what happens to these radios for these to be broken?
I am told I sound nasally. well, that's just not me! But after seeing the Frequency response of 500hz to 5k it seems to cut a bit of fundamental voice off. I think I know what to do but I'd rather have your expert information before I screw up something!
Am I correct that replacing the .001...
@NightThumper
Excellent thread! I just replaced the 4.7u electrolytic cap on my Special, mine was high off the chart ESR. Someone also wired the negative battery connector to the wrong place bypassing the on off switch which results in a dead battery. I think some people don't even look...
HI,
I have this old Galaxy DX 949 that has a broken L15 ECIFT12258 , anyone have one?
Since this poor radio is a mess, I mess with it in my spare time. The Issue: Receive is two channels off, 10.2400 is right on, L14 adjusted for 3v. Next step PLL alignment and someone broke L15. This...
hi @danmcclain Great thread!!
Would you possibly have the schematic for a Gemtronics gtx-3000? Also a picture of top and bottom of the circuit board if possible.
Thanks!
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.