Recent content by Johnny

Hello, thank you ! I'll try to cut a small part in the wood part where the window close. And is it bad if for exemple my radio gives out 20W on a dummy load, and on the antenna with a matcher it gives out just 4W (which is enough for me) but with absolutely not any SWR but really nothing, the...

I found what resistor to put and where to solder it and I succeeded !! Now it works very very well ! I'm very happy thank you very much !

Hello, I succeeded to take out the PCB of the front panel but now I have another problem, where it is written IC701 it is under the LCD screen and there isn't any microprocessor, on the other side of the PCB there is microprocessor but not any IC701, Do you know where it is located, and where...

Sorry I did not understand before this moment, So yes I should solder a resistor, do you know what resistor it is ? And when he say "Remove all the knobs then Remove the front panel carefully" How to remove the knobs, just by pulling on them ? Thanks

Hi, thank you for your answer but I already read that, I looked on the circuit board but the resistor in a transparent plastic tube as said is already there. Should I add one or short something to make it able to put in export mode ? Thanks.

Hello, for my CB antenna as I prefer not to make hole in the wall to get the wire I used a piece of flat ribbon wire to pass it thought the closing of the window, it is supposed to be used with satellite dish for TV but inside of the wire the RF ribbon is very thin and the ground is very close...

Hi, I've bought a used President George CB radio but I can't put it in export mode, I've tried a lot of times to do these instructions : a) Turn your set on by pushing POWER. b) Turn your set off by pushing POWER, c) Depress POWER and keep pressed down. Your set goes on and then goes off. d)...

Hello, I just want to introduce myself, I'm called Johnny. I am from Ans in Belgium, I only use CB radios. And I am happy to be on this forum.