Update:
Second e mail sent.
Got a reply from Quxaing today.
Short, to the point.
"Sorry not, the hardware is different."
So that's the word from the guys building them.
73
Jeff
Thanks for this info. I just got a 6666 so I will be looking at this again.the NPC / swing mod will work for the anytone quad 6, Stryker 955, Stryker 655, the anytone quad 5 and quad 5 end, it's all the same circuit. Cathode of 1N4148 signal diode to center pin of the a.m. regulator. I add a 47 ohm 2 watt resistor for slightly more peak, you can use up to a hundred ohm or more if you want to tighten the peak a bit. Solder the resistor to the anode and the other end of the resistor as pictured to the rear most solder joint which is the positive pin of a capacitor. Do not short the two or you will fry the PA stage. Heat shrink it and enjoy.
I have to ask since I know you now own one. Did you mod yours?Here is the picture from Tim in case anyone missed it. This info is on page seven.
View attachment 46063
Not yet. I thought about doing it to run a 4 pill. I will have to see if I have the right diode.I have to ask since I know you now own one. Did you mod yours?
I did not do the NPC-RC or RWB mod on my AT-6666 (plenty of swing IMHO) which uses IRF520's in a 1x1x2 configuration. I
Incoming Region Produces X3 Solar Flare |
May 15, 2024 @ 14:55 UTC |
Another major solar flare, but this time from an active region just beginning to turn into view off the east limb. It is possible that the group responsible is old AR 3654 from the previous rotation. The latest flare, an X2.99 event just peaked at 14:38 UTC (May 15). Stay tuned |