i just installed a dual phased antenna system with 4' wilson fgt fiberglass antennas with 5" hd springs. i have them mounted on each side of my toolbox. the readings that i get are well over 3 throughout the board! any suggestions?
Yes, use a SINGLE antenna! Your dual antenna set-up is most likely too close to each other to give you the desired results.dway87 said:any suggestions?
Master Chief said:Yes, use a SINGLE antenna! Your dual antenna set-up is most likely too close to each other to give you the desired results.dway87 said:any suggestions?
I recommend the P-10K mounted in the center of your tool box (if you refuse to mount it on the roof).
I don't even recommend dual antennas for over the road trucks! SINGLE ANTENNA - SINGLE ANTENNA!!!
BOOTY MONSTER said:if you really want the dual look just connect 1 antenna . do not use the coax you have now with one antenna . always use the best coax you can .
id check the swr before i went into grounding stuff . if it tunes nice and low and your tx/rx is good i wouldnt worry about it .
Incoming Region Produces X3 Solar Flare |
May 15, 2024 @ 14:55 UTC |
Another major solar flare, but this time from an active region just beginning to turn into view off the east limb. It is possible that the group responsible is old AR 3654 from the previous rotation. The latest flare, an X2.99 event just peaked at 14:38 UTC (May 15). Stay tuned |