I'm sure this is a lot easier than I'm making it but I'll be darned if I can figure it out. I'm working on a large scale modeling project and need to import a lot of individual files into EZNEC for initial bench-marking and then validation later on.
Every time I import a set developed in inches, EZNEC converts it to millimeters. I can't for the life of me find the information on how to set the unit defaults to prevent this.
Does anyone know how to do it when you're just loading wires into an existing file?
Every time I import a set developed in inches, EZNEC converts it to millimeters. I can't for the life of me find the information on how to set the unit defaults to prevent this.
Does anyone know how to do it when you're just loading wires into an existing file?