56 OHMS 3 WATTSWhat wattage rating and value were those choke resistors?
To ground? Filament voltage should be around 5 volts, measured across the two pins...loaded or unloadedon V1 PIN ONE I HAVE 6.7 VOLTS and v2 pin one 3.4 volts
The top section of your DC plate choke, has arced and and fused together. It is visible, with black carbon deposits on the porcelain insulater, in the middle picture of the post I responded to, when you blow it up.Getting better 1st picture is V1 2nd picture V2 and new parasetic design with 47 Ohms measures 0.56 0hms at the end
Incoming Region Produces X3 Solar Flare |
May 15, 2024 @ 14:55 UTC |
Another major solar flare, but this time from an active region just beginning to turn into view off the east limb. It is possible that the group responsible is old AR 3654 from the previous rotation. The latest flare, an X2.99 event just peaked at 14:38 UTC (May 15). Stay tuned |