im going to be changing the channel display in my cobra 29ltd and i was wondering, is there a mark on the new diplay or a way to tell which is the top? i would hate to go thru all that work and solder all those pins only to find out i put the display in upside down.
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
changing the channel display
- Thread starter groundwire
- Start date
Look for the decimal points on the new display. That’s your bottom. They’re not connected in the 29’s circuit, but you will clearly see those dots on the bare display beforehand.
Ok cool. what if the new display i bought does not have decimal points on it, is there another way to tell which side is the top?
The manufactures part number is usually on the bottom. Also you may find a small notch or spot mark on the bottom side. I did find a rare one I had with no decimal points, but it did have a notch indicating pin 1.
If it's the workman 4233ba or 4233ra I've noticed that it's opposite on those. Not sure why they decided to label them that way but they have been for me.
I got them from the ebay seller six-star.
The pic shows the decimal points on them. I hope thats the case. No guesswork
The pic shows the decimal points on them. I hope thats the case. No guesswork
Note: One of my favorite replacements is the LITEON LTD-482G-09. There’s a few CB’s that require extended pins, otherwise the readout will sit back too far away from the lens. These also come with blocks to help support the added length. Of course those pins can be cut to any desired length.
https://optoelectronics.liteon.com/upload/download/DS-30-99-155/D482g-09.pdf
https://optoelectronics.liteon.com/upload/download/DS-30-99-155/D482g-09.pdf