You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

Shockwave you commented the other day that my models of the 1/2 wave dipoles source location was off a bit, and thus had a bad influence on the results I was presenting. I posted I would use the split function then and get the feed point right in the middle of the dipole, but I forgot that Eznec does not allow us to use the split function on a wire junction with three or more connections. I used two wires to make the dipole so I could connect the mast in the middle, and thus I end up with a three wire connection.

How much do you think the source results currents could be off due to the source point not being right in the middle of the dipole?

[QUOTE="Marconi, post: 419983, member: 903"] Shockwave you commented the other day that my models of the 1/2 wave dipoles source location was off a bit, and thus had a bad influence on the results I was presenting. I posted I would use the split function then and get the feed point right in the middle of the dipole, but I forgot that Eznec does not allow us to use the split function on a wire junction with three or more connections. I used two wires to make the dipole so I could connect the mast in the middle, and thus I end up with a three wire connection. How much do you think the source results currents could be off due to the source point not being right in the middle of the dipole? [/QUOTE]

Top Bottom