Hi, I have a LT-2N echo board and would like to install it in a RCI 2950. Can any one help me. Would really appreciate it. Thanks
Larry lekau@pa.net
Larry lekau@pa.net
-
You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Help wiring a echo board
- Thread starter larryk40c
- Start date
The echo board probably has two sets of shielded audio wires, then a positive and negative wire. One set of audio wires are the input. They connect to the mic connector on the inside of the radio. Go to CB tricks for mic wiring info Ranger RCI-2950 Service Manual
to establish the pins you need to work with. The output set of shielded wires go either the cicuit board as you see here at :39 into the video
Ranger RCI-2950DX with TRBX3 Echo Slider and Talkback - YouTube
or you can connect them to the two wires you disconnect from the mic plug.
3's
to establish the pins you need to work with. The output set of shielded wires go either the cicuit board as you see here at :39 into the video
Ranger RCI-2950DX with TRBX3 Echo Slider and Talkback - YouTube
or you can connect them to the two wires you disconnect from the mic plug.
3's