Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Kenwood TS-50 display light flicker

N

n8fis

Member
Nov 4, 2012
3
0
11
My TS-50's lighting display acts as if there is a bad ground. No matter what display light brightness you set it at, it will flicker back and forth to full brightness then back to the setting you set it at.

I've looked for this problem a few times now. I even soldered some ground jumpers in hopes to get a better ground to the display.

Anyone else run into this problem? If so, what is the fix?

Besides that the rig is 100% except for it's matching tuner the AT-50 needing reset once in a while.

Thanks for any replys.. Bill N8FIS
 

bad transistor?
cant remember how those are dimmed.some have a resistor and a tr to bypass and some use a series pass.
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom