You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Reply to thread

Message

It's been a day or two since then, but as I recall, I removed a 1/2" from the ends of the driven element (dimension B) where it is separated from the reflector leaving all other dimensions as they were. I may have done this more than once until I was satisfied.
I did not change the width of the antenna, nor the gap at the feed point.

[QUOTE="HomerBB, post: 494859, member: 8569"] It's been a day or two since then, but as I recall, I removed a 1/2" from the ends of the driven element (dimension B) where it is separated from the reflector leaving all other dimensions as they were. I may have done this more than once until I was satisfied. I did not change the width of the antenna, nor the gap at the feed point. [/QUOTE]

Top Bottom