• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

need help..VX-8R locked

nina_sayang

Member
Sep 9, 2012
1
0
11
45
hello...
i have a problem for my yaesu vx-8r. device is totally locked with "key symbol" and showing only one dot. i can't press anything, even when i remove the battery and attached it again still displaying the same problem
i really need help to this problem.
thank's.

vx8r-problem.jpg
 

Try holding the power button in for a few seconds till it beeps. Although when the keypad is locked you can still read the display. I have never seen a key symbol on the display. Have you tried a full reset?
 
You might try calling Yaesu's technical support. They just might be able to assist you with one of their products. :wink:
 
I don't know how Yaesu unlocks, but when I bought my Wouxun commercial dual band radio it came locked, and I had to hook it to my PC and use the software provieded to unlock it before I could use it. You may need to contact Yaesu. On mine when I lock it I simply hold the lock button down for 3 seconds and it beeps then unlocks the radio.
 
Have you tried a hammer? Lol jk.
I am very sure friendly techs at yaesu can assist you over the tele or email.

Sent from my Xoom using Tapatalk 2
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.