You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Reply to thread

Message

Welcome.
I could duplicate your setup by adding a Maco boomer kit but use rigid aluminum tubing that I have on hand.
The way you electrically isolated certain parts of your antenna has my interest in particular as I was debating wether or not to isolate the mounting position on my A99. I could kinda match your radial slope angle by pulling down my SS 102" radials on my modified GPK-1 ground plane. I would like the heavyweights here on the forum to weigh in with their thoughts and perhaps some antenna modeling to see just your antenna configuration is doing.
Thanks for the idea.

[QUOTE="Lil'Yeshua, post: 458757, member: 28438"] Welcome. I could duplicate your setup by adding a Maco boomer kit but use rigid aluminum tubing that I have on hand. The way you electrically isolated certain parts of your antenna has my interest in particular as I was debating wether or not to isolate the mounting position on my A99. I could kinda match your radial slope angle by pulling down my SS 102" radials on my modified GPK-1 ground plane. I would like the heavyweights here on the forum to weigh in with their thoughts and perhaps some antenna modeling to see just your antenna configuration is doing. Thanks for the idea. :D [/QUOTE]

Top Bottom