Uniden Grant

[Sonwatcher]

I have a plain Uniden Grant not xl or LT. I was checking out the channel mods and some said pin 10 does not have a trace to cut . Is this true of this board ?? The board is a PC-409AC. It has the MB8719 PLL.

God bless you all !



CDX-897

OT-897

WV-897

CM-2368

American Kangaroo-1897</p>

 

[Sonwatcher]

I have a plain Uniden Grant not xl or LT. I was checking out the channel mods and some said pin 10 does not have a trace to cut . Is this true of this board ?? The board is a PC-409AC. It has the MB8719 PLL.

God bless you all !



CDX-897

OT-897

WV-897

CM-2368

American Kangaroo-1897</p>

 

[Sonwatcher]

I got it.

Here is a good mod that only requires 1 switch instead of 2. !



www.cbsite.nl/modif/onder...mb8719.htm



It is for Uniden Grant/Madison, Cobra 148/2000 GTL etc



I have found that if you do not have a trace on pin 10, the 2 posts that go to ground DO NOT. The ground post next to pin 12 goes to post with pin 11 wire and the ground post below pin 10 wire goes to post with pin 12 wire. This will give lowers,cb,and uppers

God bless you all !



CDX-897

OT-897

WV-897

CM-2368

American Kangaroo-1897</p>Edited by: <A HREF=http://pub86.ezboard.com/bworldwidecbradioclub.showUserPublicProfile?gid=sonwatcher@worldwidecbradioclub>Sonwatcher</A> at: 2/14/04 4:44 pm

 

[Sonwatcher]

I got it.

Here is a good mod that only requires 1 switch instead of 2. !



www.cbsite.nl/modif/onder...mb8719.htm



It is for Uniden Grant/Madison, Cobra 148/2000 GTL etc



I have found that if you do not have a trace on pin 10, the 2 posts that go to ground DO NOT. The ground post next to pin 12 goes to post with pin 11 wire and the ground post below pin 10 wire goes to post with pin 12 wire. This will give lowers,cb,and uppers

God bless you all !



CDX-897

OT-897

WV-897

CM-2368

American Kangaroo-1897</p>Edited by: <A HREF=http://pub86.ezboard.com/bworldwidecbradioclub.showUserPublicProfile?gid=sonwatcher@worldwidecbradioclub>Sonwatcher</A> at: 2/14/04 4:44 pm