You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
The Feb 2025 Radioddity Giveaway Results are In! Click Here to see who won!

Reply to thread

Message

I've been using Megawatt PSUs for some time. I parallel two 50A to run my DX-500 and I use #6 cable to tie them and [power a hub that connects my Amp to the power. My idle voltage is 14.2V and during full output I drop to 13.9v. Never lower. These readings are taken at the hub where the amp is connected. I also use an independent 50A Megawatt to run my SR-955. It idles at 14.6 and drops to 14.5v when TXing. I know you'd like the answer as to why you have this issue, but if you decide to change PSU I would just recommend Megawatt.

[QUOTE="Greg T, post: 852507, member: 42791"] I've been using Megawatt PSUs for some time. I parallel two 50A to run my DX-500 and I use #6 cable to tie them and [power a hub that connects my Amp to the power. My idle voltage is 14.2V and during full output I drop to 13.9v. Never lower. These readings are taken at the hub where the amp is connected. I also use an independent 50A Megawatt to run my SR-955. It idles at 14.6 and drops to 14.5v when TXing. I know you'd like the answer as to why you have this issue, but if you decide to change PSU I would just recommend Megawatt. [/QUOTE]

Top Bottom