Toggle sidebar Toggle sidebar
  • You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Yaesu VX-8 after TX-extension, 4m RX in NFM not possible

D

DD7GX

Member
Jul 25, 2009
2
0
11
After TX-extension is the 4m band unfortunately only on WFM possible!:headbang
I have a TX-extansion in the range 120 - 135 Mhz TX does but I would also like to mention 80 - 89 Mhz in NFM received.
Who knows about it and is familiar from so?
 

80-89Mhz is just below the typical U.S. FM broadcast band. My VX-8 only RX in WFM mode there. I'm not 100% sure if it was that way before expansion, but I'm pretty sure that it was.
 
Probably you done diffferent mods.
Hardware mod doesn't modify 4m (70MHz... not 80-89) modulation type (NFM-WFM).
Software mod forces to WFM....
 

dxChat
Help Users
  • No one is chatting at the moment.
  • @ BJ radionut:
    +1
  • @ heartbreaker3473:
    Hello gentlemen and Ladies. I have the dreaded RCI-2990 receive issue where my radio gets distorted when people get close to my location. I found the C90 Capacitor, but I can not for the life of me find the C89 capacitor. Can or does anyone have a picture of the exact location of C89 ? Thank you in advance, Wes
  • @ AudioShockwav:
    Wes, it's better if you start a thread on the main forum, more people are going to see your question.
  • @ heartbreaker3473:
    Okay, sorry, will put in a forum
  • @ heartbreaker3473:
    I put it in the general disscution help area and started a new thread. Thank you for letting me know.


      Top Bottom