You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Welcome triple2. This is a great site with what seems to be alot of knowledge handed out for help. Great group. Waiving a hand from 345 in the mobile on lower 38
Skip HAS been running well the last few days. Using my 949 with recent purchase of the ts350 made contacts in N. England,Montana,Cali, & a couple others. 345/doc in this 18 wheels of steel
On initial testing I put it with my galaxy dx 949. With my cheap meter in truck it showed on key up @ 80 watts,the swing in not sure of cause cheap meyer only goes up to 100watts in truck. Audio reports I got back was crisp clean audio.So that was a + to hear. Thanks again for all the help. I...
Just last night picked up a Texas star dx 350 hd from a driver getting out of trucking for $100. Seems to work well with no obvious dents,scratches etc. The inside looks practically new also,with no odor of any burnt components. He had it on & was using it while selling. Sounded good without it...
Thanks!!! You guys have been really helpful. Thanks for all the pointers & tips.. Much respect for all of you with knowledge of radios. I wish k would have gotten into learning them at an earlier age.. My hats off to you..
Ok thank you all again. I will look up the parts list for the 2517 or like board to compare. I was kinda thinking that the biasing wouldn't be set properly by that method, bit hey I'm a newbie/beginner/rookie to all this.
Yes ,I do have a heat sink for it, but was wondering more along the lines of where is the 2nd mosfet final getting its biasing from on the "cbtricks" site. Thank you again
yes I have my gate voltage set & 3.45+-. Just wondering if I set up the second irf520 in the second stage then wouldn't I need a companion part for that transistor( doesn't show one one on the CB tricks site. I know I could shadow the parts as in the first final. Guess what I am curious about is...
Ok I know that some will say its not worth it before I begin! I was wondering when adding the 2nd mosfet to a 949/959.... On cbtricks its going off of the 1969 version it really doesn't show biasing the 2nd mosfet with a companion part. Wouldn't it need the same biasing. Just curios!!! Now I...
Ok I just bought this recently for $50. After opening it up & paying more attention to it, I found out its the HP model with dual finals. I have seen elsewhere tuning locations for the one with a single final. Can anyone shows or guide me in the correct direction as if the same tuning points are...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.