I am having some issues with my SWR, when I check the SWR on CW on my HTX-100 it reads a 1:1:3 on 7 and 25 watts out and when switched to SSB the needle never goes past where it was when I set the SWR cal. on CW, but when I put my JAWS II 150 ( a 150 watt amp) inline the SWR swings from nothing to full scale, I know your not supose to check SWR on SSB but I was concerned about this since when I switched to SSB from CW to cal. the SWR it never went past the SWR readout on CW until after I added the amp.
Update: just took an SWR reading with the amp inline on CW and it reads 1:3!?
T23
Update: just took an SWR reading with the amp inline on CW and it reads 1:3!?
T23