4.7UH Surface mount inductor question with picture.

[Low_Boy]

All good. Face plate has been removed. All traces check good. The shorted choke goes to mic. Pin #6. 13.8V someone must have grounded that pin somehow. If radios could only talk. Having separated two of these radios in the past I am hoping. I can do this solder job without separating the two boards

 

[Handy Andy]

Fingers crossed...

 

[Robb]

This is why I use fine point soldering tips . . .

 

[Low_Boy]

This is why I use fine point soldering tips . . .

I have a tip that is on a angle that should fit right in the lower spot near the volume pot.

 

[Robb]

OK.
Just remember not to overheat those traces, as they will start separating/lifting from the board.
Got flux?
Use it.