I messed around with the radio a little bit last night for a few minutes, I didn't get the scope out and check the audio chip yet and it may be the culprit. I caught it with very low recieve and flipped the radio over to PA and I didn't have any audio with a external speaker on the PA jack so I flipped it back to AM keyed it and the recieve kicked back in then I flipped back to PA and had mic audio there then ! I started looking over the radio farther and noticed one of the black wires coming from the mic connector that goes to the mic gain pot was very loose at the solder joint on the pot board so I touched that up and it hasn't lost recieve volume since, I sure dont know what that would have to do with the recieve!!!! But.... it kinda seemed like the longer I used the radio the longer it would stay good perhaps it is a weak cap or something somewhere too, we'll see what happens if guess