You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
How did you handle desoldering? To me... THAT is the biggest time chewing factor of all . I was fortunate to get a little cash to put in to a soldering /desoldering station. On a PCB that made it so much easier!
I understand how PLLs work ... Use phase difference to create a control voltage that tunes in the VCO.
I'm just trying to get a handle on ... If I put my scope probe on a buffered test point on the VCO..... Would I see a great big signal? Or would I see a little bitty tiny signal?
That is...
KANE-4109 here. When I became aware of CB licenses they were $20. By the time I got a radio of my own and applied for a license it was only $4. It took about 2 months to get my paper license back and, about 2 months later, I got my $4.00 check mailed back to me as they had done away with...
Just found this thread and have a related question. I know that they have all kinds of fancy analyzers but, on the more simplistic side, what do you need to perform most RX/TX alignments? I'm sure a good frequency counter, a scope with decent bandwidth, perhaps a vacuum tube volt meter, but...
Helping to narrow it down, here is what I remember. All through 1976 I was salivating all over my father-in-laws CB gear. Christmas 1976 she bought me a JC Penney Pinto 23 Channel AM mobile. WHen I got that, I discovered that the fee had dropped from $20 to $4. So I filled out my...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.