Recent content by Fino

Does that one load control on that Maco set deadkey like a Blackcat on steroids since they call it a modulator.

I just recently got a 4 6LQ6 that appears homemade, need to clean the dust out of it before I can power it up curious what it will do.

Nice station you have there Lik2race.

Is very clean looks new.

Why the edited posts and I assume pics of amp?

Now that's a design problem!!!

I don't think you need to do anything, I didn't with my 200.

It's probably working fine, what radio(s) are you using with it? If your using CB will only get output when it's set to 10/11 meter. Would also need antenna or dummy load for the other frequencies and SWR meter as well. As for power output I'm sure someone here can tell what you should get out...

And in case you don't know if you touch the wrong thing in there with out bleeding the capacitors can get hurt real bad or killed.

Band is frequency 11 meter is CB band. If the switch is actually hooked up you will see wires from it going to coil off the back of one of the tuning knobs each at different places to get the different bands. If there is just one wire on the coil is just 10/11 meters. Even does have other bands...

Well I guess if you were real determined you could use that one as mobile too, that beast of power supply looks like you would need a forklift to pick up.

Or if you look at back of switch will see it's not connected nor was it ever connected to anything just there to get by FCC. That's how my Thunderbolt is.

http://www.bunkerofdoom.com/ Untitled Normal Page

Jaws II RF Linear amplifier, Henry RF amplifier, Harris MSP100 audio processor

BOMADE Mobile 2 x 3CX15,000A7 Class C Normal Bird Dead Key: 65,000 Watts Max Bird Dead Key: 80,000 Watts Suspect it might cause a little TVI???