Recent content by GreenTeg

You can also throw a K40 speech compressor in that mix, if you need one, I have one I can send out to you. Mobile though, I always recommend a 636 or a shure 577b, just hate that background noise.

Galaxy 959 would be a great choice. A 2 or 4 pill amp would complement it nicely as well. If you only want to do AM, there is the Galaxy 919 and the Magnum S3. If you want just a big ole' radio without an amp that does EVERYTHING, then the Magnum S9 is for you. They even make a 80 and 175w...

Hey Robb, nice finally chatting with you today. When I said 577b mic, you thought I was talking about this new unit, my apologize. I meant the Shure 577b cartridge microphone with true noise cancelling abilities (not just some foam stuffed into the case. Anyways, hope I was sounding nice...

Depending on how tall your Civic is (I have an Integra) you might opt for a 66" whip from Wilson instead. It brought my SWR down quite a bit...1.1-1.3 instead of 1.5-1.8. Good investment of $10.

General Mobile Radio Service (FM/Repeaters/Pain in the Ass) General Mobile Radio Service - Wikipedia, the free encyclopedia Family Radio Service (FM) Family Radio Service - Wikipedia, the free encyclopedia Multi-Use Radio Service (Already mentioned 154mhz) Multi-Use Radio...

Just wondering, did you happen to see where they mounted that $600+ antenna? In a shitty spot with hardly any ground plane. Looks to me like a scam, or that someone obviously didn't do their research. I'd even bet that the simplicity of a Wilson 1000 (I own and use one) properly mounted...

Make sure that when you adjust your VR18 that your RF power knob is fully counter clockwise and while adjusting your VR14 the RF power knob is fully clockwise. Where is your mic gain set?

Nice write up Rob! I was looking to get either this or a rfx75'd cobra 29 for the truck. Now you've made the decision even more difficult. We'll see how the wallet unfolds.

Would anyone in San Jose, CA be willing to do these modifications to my chassis for me? I am also sure that the rx/tx align is not perfect, and would probably want that done as well. Thanks again everyone. You guys are definitely saving me money on equipment I don't need like a pre-amp and...

Don't worry about posting links. I just spent the last few hours searching for the best prices on these things (sad to say), and found them all. I will be doing all 7 of these changes to my board to help with the future amplifier upgrade. Now I just need someone with better equipment to do...

Rob, would you mind posting a link to some of these online sales or possibly doing these modifications for me? I am greatly familiar with this link: The Defpom EPT06960Z Galaxy 949 / 959 modifications And have been told that most of those modifications are actually bad. A swing kit for...

Pre-Amps : RadioActiveRadios.com This was the preamp I was talking about when I mentioned it earlier. Any opinions on something like this?

For what I have found, the 636L mic theoretically works perfect for me (have yet to try it out). I have a very loud voice when I talk, and it is consistent, the only thing I needed was excellent noise cancellation, and that is what the 636 was known for. When I talk on CB, I commonly am using...

Would a stand alone preamp be better suited, or is it still using the same technology?

I've already got it on my to-do list over here. The car isn't with me up here at college though, so I'll have to wait another month to get cracking on these projects. I have foam boards that I use for DJ equipment when I run my laptop, and it is not only great for heat dissipation, but it is...