You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
That Rg-213 will work just fine and is in fact what JoGunn recommends. I am currently using JEFA Tech low loss 400 flex coax that is also very similar to LMR400 UF. You can check it out here --> JEFA Tech: Low Loss 400 Flex Coax - By The Foot . Good luck with your little project...
Another thing I did before I started using the aux on the stereo was to use one of a pair of Bose Environmental 151 speakers. It worked very well. I now have the pair of 151's on my base station :)
It is a simple setup for me. Since the aux input is not on the stereo itself, but in the lower center panel where the power port is. Requires just on cable from that point to the cb radio external speaker jack. The adapter simply matches a mono external speaker output from the radio to a stereo...
I have the output from my external speaker jack go through a mono-stereo adapter then a stereo 3.5mm cable into the stereo aux input on my factory stereo in my 2011 Tacoma. Serve it's purpose very well.
Yup. One option entails going to the local hardware store for a length of copper flashing from the roofing department. One ten foot length cut into 1 inch strips will provide ALOT of ground strap.
Just call Xforce and ask them. 847-561-4971 I'm certain they have the answer to your question. You'll get a lot of good advice here but if you want to know what the builder means by the specs provided you should ask him. If you tell him what your set-up is he'll tell you exactly how to run this...
I had a similar problem with a SuperStar SS-158EDX. What I found was that the wire going from the circuit board to the SO-239 center was not soldered good and would make intermittent contact. Easy fix with a hot soldering pencil. Not the only issue I had with this radio and not the last. Just...
102 SS whip
I would put the 102 + 4" SS extension + 3" quick release midway between the front and rear bumpers and in the center line of the roof with a puck mount. That should improve the looks of that or any vehicle! :thumbup:
All kidding aside that worked just fine for my ford ranger...
I had an old pair of Bose environmental 151's laying around so I plugged them both into my Uniden Madison and mounted them just above head level about 4 feet apart facing the "radio operator position". It was like wearing headphones. When I switched to the Galaxy DX2517 on the base, it only had...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.