You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Thank you, Warren. I did see that long trace and was wondering where the feedthrough went, my readings make perfect sense if it goes to ground. That is not shown on the schematic for some reason.
73, Bill
Low measured resistance from input/output connectors to ground, why?
I replaced the input and output connectors on my Larcan (K4DLX kits) and was surprised that I read a short on my ohm meter from the center pin of both connectors to ground. I assumed I had messed up and inadvertently soldered...
I mentioned the internal power adjustment in the FT-847 but was later informed that this does not stop the spike, the only way to get rid of the spike is to perform this mod:
ALC_FT847_cz_cast.2
I have not yet tried it but it seems fairly easy.
73, Bill NZ5N
C6ANU,
We could probably work direct on 6 or 2m, I am near Ft. Lauderdale. Have had several QSOs with C6ANX, also named Mike, also in Nassau. Good luck with the project.
73, Bill
Just bought 3
Hello folks,
This is really an interesting thread, sorry it seems to have stopped a month or so ago. Does anyone have their Larcan on the air yet?
I am awaiting the arrival of 3 Larcans (lo-lo) and have been reading as much about them as possible. With respect to some of...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.