You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
I have them all correct, I even verify the schematic. I constantly keep on going back to this point. Where TR-13 point 14 should be 0v but there is 9.43v all the time. at TR13 squelch range it should be .65v-8.11 open squelch is 9.43 close is 8.13v I don't think it should be like that, not...
Hi Andy. I am comparing capacitor direction from the image you send me from inside your radio. I know as C232 ground (-) on my radio is facing away from the radio chassis but yours (I am not sure) is facing the chassis. Do you have an other image from the section near the TA7222? to compare the...
That is exactly what I was doing. I have found that there are no marks on the board of + from C132 and C148. I am going to flip them and see if I get something.
When I transmit with the radio I can hear myself on an other radio, I even ask for radio check and getting responds. (on channel 19–27.185)
Microphone pin 2 (shield) test on all IF caps making the sound of a short.
Microphone pin 4 (common ground) test it to all caps making the sound of a...
Once I read your respond, my concern was the mic wiring.
I have a Road King 56 microphone.
Pin wire
1- White
2- Shield
3- Black
4- Red
5- blue
From the microphone board, pin 1 goes to Dynamike – pin 2 to the board to one of the pins from C106. Pin 3 green wire to rear speaker shield. Pin...
Thank you for your help Andy.
I verify the IC4 these are the voltages.
Pins
1) 9.36v
2) 13.02v
3) 13.02v
4) 0.0v
5) 13.02v
6) 9.57v
7) No pin on board
8) 0.6v
The TR35
TX
USB-LSB-AM had the same results
0.0v 0.07v 0.81v
RX also had the same results
9.0v 12.87v 9.26v...
Update. I have found this voltage on the PA. and 0 volts on AM...
I cannot figure out where power is coming from. I believe this is my issue the radio doesn’t go back to RX.
PTT light is green
Does anyone have any idea?
I appreciate your help...
I find few capacitor that I did installed wrong... I have replace them and seems with the same white... I did check TR-15 it is in good working condition, I have purchased a Atlas DCA55 just for that task.
I know as something different under R43 resistor without...
Update. I received the caps and replaced them, voltage still a little high, but stable. All the channels that were not working, now they do.
I can see modulation on the Oscilloscope BUT I can't hear anything ONLY white noise. (Soft white noise). I unplug the antena to the dummy load and is the...
Update from last night.
I was able to recover all the channels from 1-40 they are all correct under the frequency chart. However, it does not change the PTT from Channel 13 to channel 2 no audio....
I am little frustrated I really don't know if is word spending so much time in a radio I had...
Good Evening.
The radio is back on and I HAVE AUDIO, I am still waiting for the Cap's to be replace. Once I replace the TR-38 I have audio modulation.
I have being checking all frequencies and I notice that Channel (1) is on 26.965 MHz then I switch to Channel (40) the frequency is on 27.325...
Thank you for all of your replies, I have trace the voltage and mic signals. However, 99% of the Voltage are high in average of 1v 1.8v, I have order a kit of dielectric capacitor to replace them all. I found a short on a TR-37 XMT and a high voltage on a TR-38 XMT almost 3 time more of what the...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.