• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Recent content by Radioman56

  1. Radioman56

    Lester Custom Truck Shop

    ...Methinks that thou protesteth too much...
  2. Radioman56

    Low Pass Filter Placement

    Well., there's certainly nothing wrong with using your DF-3000 for HF use up to 30 Mhz, as the factory spec-sheet states 60dB @ 60 Mhz (no rating at 40 Mhz) but am quite sure it's at least 40 dB @ 40 Mhz.! The original theme behind this "thread" was simply the OP asking whether to place the LPF...
  3. Radioman56

    Low Pass Filter Placement

    Great to hear you'll give it a "real-world" test.!! Especially if you're using a typical / non-commercial, UHF band / 450 Mhz, GMRS transmitter., you'll certainly see ALL of it being reflected back from a typical 30Mhz LPF (as the Drake TV-xxxx models have a factory stated spec of 80dB...
  4. Radioman56

    Low Pass Filter Placement

    The "bottom-line" of "passive" (not "active") low-pass-filters (and to back-up our "chastised" member "DudMuck" here ;-) All LPF circuits / boxes WILL produce reflected power from any / all harmonics that are being suppressed by the LPF., AND will affect amplifier performance.! The RF power...
  5. Radioman56

    GAMMA MATCH LOCATION

    Well agreed 'Doc'.!, and to add 'my 2 cents' to the matter (hopefully without stirring-up a bee's nest.!)., is that when setting-up a larger Yagi (ie: 10/11m compared to a much smaller VHF / UHF) in the vertical mode., that one should place that side-mounted gamma above the boom. Yes / no.?? I...
  6. Radioman56

    Lester Custom Truck Shop

    Yep., that's why I always do my best to never have more than a half-dozen radios and / or amps (in total) waiting in line to be repaired.!! It's also limited to "an appointment only basis", starting with a preliminary, semi-technical, telephone chat (so that both parties can / will be of the...
  7. Radioman56

    ERF 7530

    As shown by the two attached "screen-shots"., the ERF-9530 states a gate-threshold of 2v-4v (using an improper nomenclature of "V/TH"), whereas the 24N40 states a gate-threshold of 3v-5v (using the proper nomenclature of "V/GS(th)" What get's me "blown-away" / amazed., is how someone / anyone...
  8. Radioman56

    RCI 2950 1st Gen

    Yes, I've also had that capacitor (C25) go "open" (ie: down into the nF range.!) which causes very weak (microvolt-wise) and very quiet (volume-wise) AM receive.! But it's more because while the paralleled resistor (R32) allows the Emitter of the last 455 Khz amplifier transistor (Q11) to pass...
  9. Radioman56

    A petition for the FCC to 'act-on' the 'Mud Duck Radio', channel 19, nation-wide interference problem

    This is a petition (on "change.org") to hopefully have the FCC 'act-on' the 'Mud Duck Radio', channel 19, nation-wide interference situation..... The problem of interference to our nation's trucking and 'pilot-car' drivers (and others.!) has been going-on for quite sometime now, and maybe, just...
  10. Radioman56

    Palomar Electronics Max-Mod. Spoiler alert!

    Ahh, yes, now I know who ya mean, as I too, am quite aware of "Mr. Lewis" and his (and late father's) tendency for the re-banding of some items.!! :( As far as any similarity of me to "main-stream-media" is concerned., I don't believe that my present BitChute channel (which was created just...
  11. Radioman56

    Palomar Electronics Max-Mod. Spoiler alert!

    You mean me.?!? :( I've been just about the most vocal person against the "snake-oil" claims of the infamous Palomar "Max-Mod" device., ever since their introduction to what I call the "up-sale" (adding / padding a customer's bill) "marketing-ploy" of "pushing" them as some type of...
  12. Radioman56

    Motorola 555 ssb base tx issue

    If you'd like, contact me (Eric) @ Klein Communications about your Motoroa 555 "issue"., as I just might have that simple "C#xxx fix" for ya.! :) https://www.facebook.com/radioman55 or at https://www.qrz.com/db/KY8E
  13. Radioman56

    ERF 7530

    Yes it (the 24N40F) can be subbed-in., but one MUST be aware (in some cases) of the LARGE differences in "VGS(th) Gate Threshold (turn-on) Voltage" between differing MOSFET devices.! The "Palomar" ERF-7530s have suffix designators (A through J) with Gate voltages ranging from 2 to 4 volts. The...
  14. Radioman56

    Siltronix VFO, boosting the drive level.

    Well my fellow electronics-competent Folks., I just found another inexpensive & easy way to get even a bit more output from your Siltronix VFO 90., or any other brand of VFO (ie: a PAL, Glen, etc.) along with a better (higher) impedance-match, especially for tube-type equipment.! It's simply...