You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Hello, I found this information in a post for the Stryker 447 hpc2, it looks like you were initially sent the wrong schematic, is the information for the 497hpc? Thats what I need it for, thank you in advance for your help.
C189 is a spot to place diode/resistor combo.
R249 AM limiter
VR14 am...
Thanks for the reply, I am on an email back and forth with one of the Stryker Techs, still waiting on definite and now it seems that there may be a tiny amount of improvement with just the 6263's Then again if its not discernible whats the point?
Man, I learned a lot reading this thread, especially that guys will fight about anything LOLOLOL, my transistor is bigger than your transistor. I have been through this thread several times looking for the location and parts to replace in a Stryker 955 to do this mod. I appreciate the help.
I have a customer with a similar symptoms and its a bad mode switch, there are several contact points in the wafer switch and if they are not aligned or making partial contact you get intermittent or partial functions. Since this post is from 2013 I am sure you have it figured out by now.. LOLOL...
I am getting ready to put up a m108 with the 3" 40 Ft boom minus 1 element effectively making it a m107 on a 40 ft boom. I noticed that the modeling was done on a 36' boom? Has anyone modeled and optimized that spacing of 7 elements on 40' boom?
Thanks
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.