You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
both RJ style cables in the kit
6 pin wires are not crossed over cable is normal round
8 pin wires are not crossed over cable is flat
the third cable is the speaker one (3.5mm mono socket to 3.5mm mono plug)
the bracket in the kit is pure crap.....a cell phone mount would be better...
1970's and 1980's had cookie cutter radios..uniden/cobra/stalker/Robyn to name just a few that used the 8719 and similar chassis
anytone is just he 2000's version
if it pains you this much just dont buy it
complaining on a interweb forum will get you no where
unless you have a spare $50K+ in...
its 2018 and I started selling transceivers in 1984 (under two different company names and privately )
In 34 years of thousands of transceivers ,ham radio.cb radio,"exports" and commercial gear to radio ops a huge percentage were ham ops of the few thousand or so ham ops
I can count about 10...
terrible radio ..both the stabo version and the superstar version ..have both
the stabo has a few things different to the superstar
neither will tx/rx across the whole coverage of the radio (when extended) and are not really widebanded in the rf chain ..better left as a 40 channel radio and...
hi
yes it can be done HOWEVER ..
40 channel am plla02a switches come in two flavors either N224>N286 (ch1>ch40 dont worry about the inverted codes in this example ) or N330>N286 (ch1>ch40) depending on chassis it came from...
now heres the bite
ssb pll02a radios use N255>N211(ch1>ch40) so as...
m1 out of the box goes into compression all modes with any thing over 31 on the mic gain (31 out of 63 steps) out of the box
probably why they are default setting for 31 on the mic gain when you reboot the radio after doing the expansion to them
if you ran a m1 with a power mic or...
not dave its mike
recap it then ..you should have about 8v/(+/-0.5v) at pin 9 of ic1 (pin6 side of R20)
then yes recap as this is a main rail feed however you said the rest of that radio works fine and this rail feeds all modes
nomad is quite right in the rf final however the crystal...
RV1 and RV2 (carrier balance controls for the balanced modulator ) adjust both for min rf output on ssb with no modulation (on transmit)
both pots have effect so adjust one for min carrier then adjust the other one working back and forward till you see no rf on rf meter..to fine tune it use a...
driver is not "volted" only the final TP8 is not there on top side of board so his statement that both the driver and final are directly connected to the main dc feed is wrong and misleading to his listeners
why do people not like "volted" final/s?
(really that is a terrible cb term but had...
really you talk some ball shit dont you scott ..damir yes is a member of nro ..so what? whats that got to do with anything ? hey he was a finetune bandcamper like you ..i had no issue with him then as i donot now ..hes ok infact we have some good times ..are you jealous?
your campaign of...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.