Yes I did see the + and - I’m not sure what u mean by chokes are they green discs those are what I’m having difficulty placingDid you look on the board it should be clearly marked. Look for a B+ the pad across from it should be the (-). You can use any common 3 pin socket and plug. Make sure the factory chokes are in place!
Awesome that’s exactly what I needed !! I had no issue determining the polarity I needed to know where those diodes or which ever they may be the green discs were pulled away and wasn’t sure purpose or placement also my connex did not have that noise suppression devices bridged between the + & - wires is that standard on all cb radios or u add that on ?The power cord? It uses a Uniden style - like 3-pin but only has two connections.
Below are some photos to help...at least I think you're looking for this information,
View attachment 23949
The outside - they have it stamped on the case to help - the red is towards the side panel in this photo it is to the right...
Below? It's looking insdie towards the power connector cutout. Note Red is on the Right...
View attachment 23950
Bst I can do if it can help!
Regards!
:+> Andy <+:
I see no garbage,andy n others are helping him
yes i kinda gathered that. But 1 like him makes it bad for all that mean wellIgnore him. Mr. Mike is also know as CDX-304 who has made his views about this site rather well known here before. He has stirred up trouble on the air and on this site so therefore I have a feeling it will be a while before he returns and when he does..............