Search results

I saw those I like the deltas with the replaceable lightning arrestor but not sure if those as good as some ect

i was wondering on some you have 1 from radio and 2 3 4 ect out of the switch to antenna. Can these be reversed to do 2 3 4 ect radios input to 1 antenna? Curious was looking at some deltas

TS-2000 mod board TS-2000X same as specific but missing crossband mod R54 Also missing is R50 and R51 But is right R53 and R53 are in place, so take them both out? For the whole RX/TX and crossband mods?

Here is the TS-2000 and it has 4 resistors and 3 come out Here is the TS-2000X M Looks like R54 is gone already But only 2 remain, R51 is also gone too, do I take these two in the R53 and R52 position out? For 60 meter mode and extended RX and TX? The boards are different...

I may be redundant ect but so far most of all of your input goes above most experts word. I do take heart to reading and all and input from here. And 9/10 it's right on the 1 is what the he'll was a good deal thing and worth a try lol.

Thanks guys I took your advice and this is what I went with, thanks again.

I'm not I just was reading on it and wondering how one version can do this and the other that.

Eimac Taylor Amperex See were Amperex out performs and could be pushed 1000 watts per tube, but is it worth it for almost $400 a tube? And what makes it better than another 3-500z?

My thought was same as 3-500z's are cheapest but never know on others. But it seems to have a good review as do other 3 and the Tubes being the cost they are is a big plus. And still get 1.5kw all day long out of them upto 1.8kH vs other two can get it loafing too but also upto 2.5kw which is...

All give legal limit, but which will give most bang for the buck in long run if tunes fail and have to replace.

Why I asked what combo would be best once choosen and installed its final, why I wanted input on what would be best choice for the TS-480.

Not rude lol geez. I'm still relearning a lot from being out of it a long long time.

I know what your saying and I look It like this I never had anything fully decked out lol, GET IT... LOL, kidding but serious note I just said to myself why not just put it in full it. Since I have to crack open the case for the TCXO I might as well put the crystals in too. Also don't think...

222DBFL, one slot is I think CW the other SSB

Understood that, but also was under the illusion of some( not on here ), that narrower was also able to reject signals from bleeding over. That's I guess was incorrect I assume now?

1.8Khz and 500Hz it is.

Damn

They new or used?

CK same and a few others just wondering how well when wanting to cut through BS on SSB ect would be better for 270 vs 500 or not that different and worth it?

So bottom like most have chimed 1.8Khz and 500hz so which combo 1) 1.8Khz and 500hz 2) 1.8Khz and 270Hz 3) 500hz and 270hz