Search results

Guy brought me his x200 and output is about 50 percent of what it was. I immediately thought the transistors were bad, at least one of them. I could feel that one of them was getting hot, so I thought there is my imbalance. I replaced it. No change. Replaced the other 2879, and no change...

She does a easy 3200W on a couple hot batteries Im pleased!

All jokes aside, I really enjoy fm

So i have had this radio put back a while. Dont remember the history of it but just that I thought the processor board was bad because the display is blank. Nothing other than the lights on each end. So, i swapped the display board out today for a known goo unit. Same problem! Any help would be...

I've learned to ignore ignorance

It is either or. I have used it in the house on a 300 amp supply and on 12v it peaks on my Bulldog meter at 3200 and on 16v looks about 4300. The Bulldog is right with a bird with the pep kit

Thanks for the info. I recently acquired one and didn't know it's value. It is new. Guy ordered it but didn't realize what it would take to keep it fed with amperage. It's a 4x12

Does anyone know anything about these

Failed Gamma Has anyone found a cure for the weak gamma match on the Vector 4000? At 1000W pep the gamma match is shorting. The insulator sleeve that slides over the inner rod is burning a hole and causing arcing to the outer gamma housing, not to mention everyone that has failed was full of water.

I am impressed with the performance of it for sure. Might would be a good idea to call up dx engineering for some better grade aluminum.

I'm a big fan of the Sirio antennas. Have tried the higher end ones. The V4k was the best performing initially but developed problems quick. It is very limber. The dead soft aluminum stinger bent over the initial install on a couple customers V4k just from the whiplash of the antenna due to...

Thanks to those who was helpful. I really appreciate it.

This is just a little 2 tube 4cx250b box

I've used this amp for 6 years with no issues. I just thought that a swap to 220v would make life a little easier for it.... By the way I have a Jon Boy box on the way :-)

It has 2 100 amp transformers

Yah well I don't want to go that route if that is the case.

Wondering how big a deal it is, if possible to convert say a 2x8 base X Force from 110v to 220v thx

I have been selling the sirio P5000 for 4 years. I am yet to find a antenna that will outperform it on tx and rx. I have personally ran 2200pep through it with the pl145 mount and 13ft 3in.of 9913 coax with no issues. I swear by this antenna. The only thing you need to do as a preventive measure...

Thanks for the quick reply. I am also looking at the LP-500. I know its not a actual"scope" but being able to keep a eye on the waveform is nice.

Currently i use a BullDog 10K meter. I can run it in line with the Bird 43P and most scales are very close on pep and rms. I am thinking of upgrading to the LP-100A but wonder how user friendly it is when it comes to peaking a radio or tube amp. Can anyone advise? Thanks Truck