Search results

Checked, tested, and even replaced all just for the heck of it with the same exact results, it's not the meter, reciever does not change channels and not receiving correctly

This is as good as I can see it loosecannon

Hi I have a Browning mark 3 reciever that is not acting correctly and wondered if anyone has run into the issues I am having, so far I have cleaned the relay in the transmitter and tested all the tubes and they all tested good ! The issue is the meter is peaked and never drops down when it warms...

Loosecannon, I don't see any reason why ya couldn't probably install a socket and use a standard Omron MY4 like I did in my other box

It is a absolute screemin demon now Nomad, running just the way it should I believe, very impressive!

That one ?

Also, should I be concerned with this ? Not sure why they didn't add the resistor here it looks like they put a drilled out set screw here instead, anyone know anything about that ?

I did find that there last night when I moved the lead of the cap on the coil and that may have very well been shorting it out ! When you zoomed in and showed my photo I thought there may have been more or sagged solder there but no it was that copper wire and I am thinking that was probably...

Yeah, alot more than it was when I first made that comment it was only wanting to do 600 tops

I will definitely look into that and let you know ! Thank you !!!!

I also have a bunch of 31JS6 tubes would I get more power out of the 30KD6 ?

I moved that cap to where you see old solder at basically

Hi Nomad, yeah I already have the 50 watt resistors for the final string of tubes but haven't installed it yet. I put 26lx6 tubes in the driver sockets for now and they seem to have the same power as the 20LF6 did, I have recapped most of the amplifier already but still had low power output ! I...

Yes, you can use the 26lx6 in the driver section without even cutting pin 7 as it is a dead end and goes nowhere

Gotta be a way to wake it up though, just not sure what that way is ! With 7 20LF6 the box ought to scream !

The photos are up in the forum, if there are any more you need or anything else let me know

Many photos here per LooseCannon's request

Thank you Nomad, you explained that very well ! Actually the original relay was acting up after I cleaned it and it didn't want to unkey, I ended up putting just a little bit more tension on the spring and now it works fine, however this is the original 2 prong or contact I am talking about

Sure will buddy, follow the new thread that is up and you will see all you want to see shortly

Yeah, I actually think it is the stronger spring causing it I believe, maybe I will mess with it later if need be