Search results

I plan on it trust me. Im just so fried right now having put a solid week of at least 5 hours a day into it so I need a little timeout. I will get you that d36 voltage shortly. Tx Am channel 19 and my 7.800mhz is dead on. I donplan to tear out the entire clarifier and test each part 1 by 1. I...

Another interesting find. When the clarifier if tuned to 9 oclock and 8 oclock, inpick up channel 38 perfectly while Im on channel 40. What a mess!

Yeah. I just saw it. Now I know some effing clown yook a jewelers screwdriver to it and most likely to every slug.

Interesting you say that. I just noticed that the slug in L24 is cracked! Now, i know that this radio has been golden screwdrivered.

I'll get that for you asap. Im taking a break for now to cogitate this conundrum.

I ised your charts to check the VCO frequencies. Even the skips are at a 10k jump. One fellow said I should replace the 8719 but Its perfect on thevtruth table pin outs. It hascto be a coil, diode, crystal or cap. Disc caps are funny things. Ive seen them shorted, hi and low resistnce short, or...

I have my own shop. Im alone there Transmit is spot on.

I pick up everyone from 38L on 39L. Superbowl is on 7. 28 is now 29. My SDR is my test radio. Its dead on. The problem is in the 142 receive. No doubt about it.

AM transmit is good at 7.800mhz. Channels all transmitnon freq. Its the rx thats 10k off. Cant seem to figure this one out.

I have not touched ct1 or ct2 at all. Im still not there becausenof my 20k and clarifier issue. You can seevthe blob of scum that was covering that diode. Im still goingbto clean it properly.

Here Ivreplaced the ct3 trimmer and put the 11.11125 crystal back into its home. Notice the blob of solder on the top ofvthat crystal? It was attacedvto the top of 2 other crystals using solder wick. A real mess and obviously overheated.

Here is that cap that seens to do nothing.why was it installed during the hack?

The red white wire is goingbto a 3.3k resistor. I could have used a better color but its temporary until I sort out all then issues. Here is that disc cap that joins the cut run. As you can see bybthe solder, its a aftermarket hack. Again, it just alters the frequency very slightly and just...

As soon as I can get my proper L13 frequency I'll know more. I do have a spare but I dont think its the problem because the truth table checks out.

The PLL

Great level of instruction there. I appreciate it. My plans though, were to remove all the mods. Technically, I couldnt explain it the way you did, but I knew hiw the circuits work interdependentl and dependently. A good refresher so thanks for that. . Im not having luck sending pics due to my...

Ok. I will. I will bebgetting back into this radio in an hour or so. Thanks for your support.

Yes. It had a ground strap on it and on the other 2 upper and lower crystals. Did I mention that thiscwas a ebay hack? Full of issues. Im trying to put it back stock. 73s

Yeah. I took off 1 lead andnit changed nothing. Im gonna getbthat pic of the cap under the board also...

I will look into L24. Thanks. Im using a 100mhz cathode ray tube type scope. The i have avdigital scope also but prefer thhe crt. The C1 and C2 i went nowhere near them as Im still atuck on the first adjustments because my only service info was a sams set with misleading info that has thrown me...