• You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.

Search results

  1. D

    My Lightning 6 Quad antenna

    As a side note on the L4+. Thanks to Marconi I have a great eznec model of the antenna but would like to put a call out to the 4nec2 experts on the forum to see if it can be converted and the variables setup so we could take advantage of the 4nec2 optimization feature. Does anyone have an...
  2. D

    My Lightning 6 Quad antenna

    Murdog, I have this L6 manual I got from Marconi, hope it helps.
  3. D

    My Lightning 6 Quad antenna

    JJD, I am very happy with the L4+. I am more of an experimenter than an operator and I wanted to see what kind of distant ground wave or some would say direct wave contacts i could make on 10 meters. Recently I became aware of a net in Omaha on Thursday evenings at 8pm 28.350 and have made...
  4. D

    Low band noise floor

    Homer, I took the easy way to build a beverage and bought a kit from here. https://remoteqth.com/two-wire-beverage.php I have a 300' ne/sw through the woods that I use mainly for 40m. Makes 40 more pleasant to listen to but it is of course directional. You have to read through the whole page...
  5. D

    My Lightning 6 Quad antenna

    I have raised the L4+ to about 12' to the boom. SWR and resonance is very similar on vertical and horizontal.
  6. D

    My Lightning 6 Quad antenna

    I found this so I understand a little bit of what u are talking about. "Folks who have studied this issue suggest that a valid range for the Average Gain is 0.95 through 1.05. Beyond that range, confidence in the results starts to drop." Considering the complexity of...
  7. D

    Antenna Analyzer vs SWR meter issue

    I use a Rig Expert 600 analyzer and a very accurate Lp-100A SWR/Power meter. The Real RF readings with the meter are nearly always lower than the analyzer readings. Especially if the antenna is not very high off the ground. I have read that this is not so unusual but I really don't know the...
  8. D

    My Lightning 6 Quad antenna

    What do you think overall? The gain is about what I expected, the front to back is not great but that is not to critical for me. What is this spec? AG value of 1.053
  9. D

    My Lightning 6 Quad antenna

    I was impressed as well when the 3.5" feed point attachment was the sweet spot for the horizontal side. I think LA quoted me the 1.5 SWR BW.
  10. D

    My Lightning 6 Quad antenna

    I'll see how this youtube link to my initial tests goes.
  11. D

    My Lightning 6 Quad antenna

    Marconi, you are really getting that figured out. This has been kind of a rambling thread but if someone follows from beginning to end I think they will better understand the Lightning Antennas dual polarity quads. And when you have the completed model that will be great! After raising to 10' at...
  12. D

    My Lightning 6 Quad antenna

    I'm glad you encouraged me to look closer. I ended up with the Horz feed at 3.5" from the end of the rod and the vert feed at the very start of the brass rod. Then I found a way to raise it 3 feet which is 10 feet to the boom and the vertical is starting to look a lot more as you would expect...
  13. D

    My Lightning 6 Quad antenna

    I forgot to mention the measured SWR is with balun. L4+ 7 ft off ground Horizontal SWR measured LP-100A BW 2:1 ~ 1.4 Mhz 28.075 - 2.01 28.375 - 1.67 28.675 – 1.38 28.975 – 1.25 29.275 – 1.65 29.475 - 2.01 29.575 – 2.26
  14. D

    My Lightning 6 Quad antenna

    Yes I think I saw a 2db change on one of your plots, I am willing to give up a little RL for a better pattern. I have some data I have collected today. I don't see a lot of change moving the feed point. I moved a couple of inches either side of 3.5" from the end of the rod and 3.5" seemed best...
  15. D

    My Lightning 6 Quad antenna

    Looks like LA may be off and maybe nobody looked close enough to notice before. I'm headed out to try direct feed no balun just short stub and 1/2wl coax. Attached is the balun specs. I don't really understand RL but it think it looks very good?
  16. D

    My Lightning 6 Quad antenna

    After you got the correct dimensions from me you really got it figured out! There is a lot to understand here so I will reread and comment later. Just 2 quick questions. 1. Moving the feed connection closer to the end of the rod should bring the resonate frequency down? 2. Is the plot in...
  17. D

    My Lightning 6 Quad antenna

    I found a mistake I made. The flexible part of the tuner wire that is 12 gauge is 123-3/4" long + 18" brass = 141-3/4". I hope this helps with the model. Hopefully the attached drawing will help clarify the other measurements. The hole spacing in the plastic is 1-3/8" and they are about 2"...
  18. D

    My Lightning 6 Quad antenna

    No, just dumb luck. Hope it hold up when in the air. Do you think the baluns may be increasing the bandwidth, I think I have seen before when adding a balun.
  19. D

    My Lightning 6 Quad antenna

    Yes they are labeled. What do you think?
  20. D

    My Lightning 6 Quad antenna

    Yes I have been pushing pretty hard in between work. Sorry I thought I posted these last night but I forgot them. I tried 1kw real rf into the vertical side last night. Every 500 khz or so from 27 mhz to 29 mhz, swr less than 2:1. What do you think about the sweeps, do i need to get it a few...