Search results

No clue just posted when i found it up

Copy what you need while its FREE! http://www.cbtricks.com/index2.htm

Needing assistance wiring mic

I want to hook up a 4 wire kenwood external mic into a cobra 29 4 pin connector.... any one know.....not just guessing?

Nothing?

I cant get any contacts with my homebrew satelite dish, but the dipole werks great horizontal or vertical.

Good day for air waves

took the radio to a professional cb shop in Indiana and had the radio realigned. They replaced r129 for free and let me watch the process and explained the scope meter signal readings. Also replaced the meter in the radio. This Cobra is back to kickin ***. Meter swings correct again also ....

Built my dummy load to 50ohm 25 watt max. On the klein it reads 50.4 ohms.......This .4 enough to cause issues or I can do the tx alignment?

Can I align the tx with out having a dummy load and just leave the antenna hooked up?

What does a "super diode" look like?

I repaired R129, Set Vr8 & Vr9 to mid point turning counter clockwise. Now when radio is keyed, watt meter reads .5watt and the needle still slams to the red.with no audio into the mic. Turning down the mic gain and radio gain has no effect.Needle still goes fully pegged. Radio meter full...

Thank you. I appreciate all the help.

Leap frog if I repair the snipped connections will I hurt the radio when iturn it back on or will it automatically limit tx and bring my needle back down.

Thank you sir.

Robb can you post a link to the correct schematic for this model. I had looked at a schematic before I originally posted and thats why I am so lost.

Sounds easy Rob. Can you explain in lamens terms please.

Probably is the scary part of your comment...

If I repair those then the swing will go back to what it was from factory?

No smashed coils