You can now help support WorldwideDX when you shop on Amazon at no additional cost to you! Simply follow this Shop on Amazon link first and a portion of any purchase is sent to WorldwideDX to help with site costs.
Need info for a Grant XL SSB 8719 with PB-208AB board. Need the main board PCB layout.Looked all over came up with alignment info and mods. ,but nothing on the pcb Layout info????? a picture of componints and thier position on the board. Thanks
Need some help hard to finf for info on Galaxy Saturn. i need alighnment info and maybe a schematic. i hope your still around to help me. thanks garyprososki@hotmail.com. any help will make my day.
I pulled the rear bord about ten days ago ,found nothing wrong. still looks like new. also before i replaced all 4 pills i checked them on my peak atlas DCA55 they all were within 4 points on the hfe. also i watch a lot of u-tube to see if i can get info about this problem. hard to find. ihave...
I already did that. I don't completely remove them i unsolder the base & collector. I have a Peak Atlas DCA55 they show O.K. like i posted. i checked base resistance and voltage they are spot on. All 4. Something else is throwing the Tune Off , I think a capacitor is the culpret. I changed 7...
I replaced the combiner with the proper one.Keyed it up and the output wattage went up with a 1/2 watt input to about 100 watts. But the new combiner resistor 100 ohm 2 watt got really hot, so i shut it down after 10 seconds.Any thoughts about what could cause this new combiner to heat up so...
i checked the bios resistor on rear board. it was a 1.6 ohm which checked open thats what blew the replacement 2sc 2879 16D08. then blew the 13.7 volt plus trace. i replaced it checked the fron board same resistor it was O.K. i.m waiting for the new combiner and new capacitor C45 to get here...
I sent it back and got the 500 that didn't work. it's about quality control. today i received more parts combiner was too big need a smaller one. also received the 1.6 ohm biasing resistor for the rear board. installed it. checked the 1.6 ohm on the front board it was spot on for it's value...
Have one 3 months old. I have had problems from the start. Never again i will purchase one...... purchased a dx 667 receive it it wouldn't work... opened it up found 2 solder joints that weren't soldered . contacted texas star told them about the problem said i couls solder the 2 places. they...
This forum does not allow a single user to have more than one username. If anyone wants to change their username contact an admin and it will be done. Multiple accounts belonging to the same member will be deleted without warning.